SEWER SYSTEMS

D-Series | DH502 & DR502 Grinder Pump Station

Grinder pump station, with dry accessway, for low pressure sewer systemsThe E/One model DH502/DR502 duplex grinder pump station is an ideal choice for multiple single-family homes and light commercial applications. Grinder pumps send wastewater from the home to the central sewer and/or treatment system through small-diameter pipes.

Featuring the E/One Extreme grinder pump, the DH502/DR502 offers a high level of reliability and ruggedness.

This model was previously known as the Model GP 2016.

Drawings & Installation Instructions

DH502/DR502 Drawings (PDF, 1 mb)

DH502/DR502 Drawings (zipped DXF, 1 mb)

Extreme Series Pump Curve (PDF)

DH502/DR502 Installation Instructions (PDF, 2 mb)

Specification — with "Wired" Level Sensor (DOC)

Specification — with "Wireless" Level Sensor (DOC)

Features

The DH502/DR502 grinder pump station consists of two pumps and tank. The grinder pumps, motor controls and level-sensing are integrated into compact units, easily removable for service.

The DH502 is the “hardwired,” or “wired,” model where a cable connects the motor controls to the level controls through watertight penetrations.
The DR502 is the “radio frequency identification” (RFID), or “wireless,” model that uses wireless technology to communicate between the level controls and the motor controls.

Solids are ground into fine particles that pass easily through the pumps, check valves and small-diameter pipe lines — even objects that should not be in sewage, such as plastic, rubber, fiber, wood, etc. The 1-1/4" discharge connections can be adapted to any piping materials that meet local code requirements.

The tank is made from tough, corrosion-resistant FRP and offers 500 gallons of capacity. A single DH502/DR502 can be used for nine average, single-family homes, and up to 24 homes where codes allow and with consent of the factory. The DH502/DR502 can accommodate flows of 6000 gallons per day.

The grinder pump is automatically activated and runs for very short periods. Electrical consumption of the grinder pump is low and will vary with actual water consumption.

E/One grinder pumps do not require preventive maintenance and boast an average of eight to 10 years between service calls. If service is required, the unique, one-piece core eliminates the need for in-field troubleshooting and servicing — the pump core can be quickly pulled out and replaced, meaning minimal maintenance costs and inconvenience for the homeowner.

Units are available for indoor and outdoor installations. Outdoor units accommodate a wide range of depths.

Operational Information

Motors: 1 HP, 1725 rpm, high torque, capacitor start, thermally protected, 240 or 120 volt, 60 hertz, 1 phase

Inlet Connections: 4" inlet grommet standard for DWV pipe. Other inlet configurations available from factory.

Discharge Connections: Pump discharge terminates in 1-1/4" NPT female thread. Can easily be adapted to 1-1/4" PVC pipe or any other material required by local codes.

Discharge:
15 gpm at 0 psig
11 gpm at 40 psig
7.8 gpm at 80 psig

US and foreign patents issued and pending.